The thin-layer mortar test block has shrunk and has not dried after being left overnight. Is it because the water-reducing agent contains that causes the shrinkage to be so severe?
The dry-mixed mortar sample is fine, but the mass-produced mortar will have a lot of dense bubbles popping up when applied with a trowel. Will this cause a hollow? Have you encountered this situation?
The water consumption is 145, the water retention rate is about 87% (it will still bubble and...
Aerated block masonry mortar formula. Could you guys give me some advice?
Cement 100-120
Coal Ash 50-80
Sand 800-850
HPMC 0.5
Water-reducing agent 1-1.5
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.